14900ks
4090
Msi mag z790 tomahawk max WiFi
6400mhz g skill 64gb
I’ve done latest x12b code and me update
I have set defaults
Then intel recommended settings for pl1 pl2 at 253 and the current limit to 307a
And the ac/dc loadline to intels default as well but I keep seeing throttles in my cores and a VIDcore voltage spike to 1.5v
I am not very bios savvy but I can navigate and find about anything on here I just need help with games crashing, never got a BSOD so I do not think my CPU is fried.
Any help is appreciated 🙏🏼
3 Comments
Also is around 2000 points normal for a 14900ks in CB 24?
I’ve seen people with 30k points but idk if it has to do with CB version
1. update your bios to the newest
2. reset your bios settings to default and start with intel default / performance settings. You get any problems while gaming? You do not need to set anything if you chose for example intel default the rest will be set automaticaly. For example I run msi extreme/ unlimited but I also got direct die cooling. If you got good cooling so do not be scared to set to msi extreme/ unlimited.
3. I see your waterpump is running at just around 2600rpm. You will get better cooling if you run little bit higher. I run my at 4200 rpm and the noise level is the same ( for ear ) like at 2400 rpm
4. some people say that deactivate c-state in bios will help. I disabled it too.
5. You can try core voltage set to override mode at about 1.39v to be safe and set LLC at 4 or 5 ( you have to figure it out if set to low or to high you may crash or get poor Performance or high temps ).
I also got 14900ks and msi mobo I can look at my settings later for you and write it here again.
Check out this video. I increased performance, and lowered voltage and temps by following this.
https://youtu.be/LCOWxz0CF18?si=mEmcWVVDt1HLYx7J